15
connected.
Start the refrigerating compartment
by pressing the upper on/off button
(1). After approx. 2 seconds,
the green light-emitting diode (2)
lights to indicate that the
refrigerating compartment is on. Start
the freezing compartment by pressing
the lower on/off button
(1).
After approx. 2 seconds, the blue light-
emitting diode (3) lights to indicate that
the freezing compartment is on.
The actual temperature in the
refrigerating compartment is shown
on the display (6). By pressing
button (7) the actual
temperature in the freezing
compartment is displayed. After
approx. 10 seconds, the temperature
in the refrigerating compartment is
displayed again.
IMPORTANT
The cores in this mains lead are
coloured in accordance with the
following code:
GREEN-AND-YELLOW: EARTH )
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond
with the colour markings identifying
the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW
core to the plug terminal marked „E”
or by an earth symbol, or coloured
GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug
terminal marked „N” or coloured
BLACK.
Connect the BROWN core to the plug
terminal marked „L” or coloured RED.
Starting up the refrigerator/
freezer
Start the refrigerator/freezer by
plugging into a wall socket. If the
mains lead has been damaged, it
must be replaced with a
corresponding type supplied by Gram
Domestic A/S or a Gram Domestic
service centre.
The refrigerator/freezer incorporates
a „stand-by function” and in the
display two horizontal lines indicate
that the power supply has been
GB
88
88
8
To Next Page
Loading...
Need help?
General
