765041477 Rev 000 40
Storage program
After termination of the chilling process, the cabinet continues into a storage cycle,
however an automatic defrost cycle is performed before the storage cycle is started.
Temperature control
:
Press to see the cabinet temperature setting; the display will show
the set temperature.
Temperature regulation
:
Temperature up: Keep pressed. At the same time, press .
Each time is pressed the temperature will change one degree.
When the display shows the desired temperature let go of the two
keys and the setting has been made.
Temperature down: Keep pressed. At the same time, press .
Each time is pressed the temperature will change one degree.
When the display shows the desired temperature let go of the two
keys and the setting has been made.
Defrosting
Beside the already mentioned automatic defrosting, it is possible to perform a manual
defrost cycle. Manual defrosting is possible during each of the chilling processes, and the
storage process.
If a manual defrost cycle is performed during chilling process, the chilling process
continues after conclusion of the defrosting.
The defrost cycle is started in this way:
Push the button.
The display shows [dEF]. The defrost LED indicator flashes.
Push the P-button to start the defrost cycle.
The defrost LED indicator is turned on.
After conclusion of the defrost cycle, the current chilling or storage process
continues.
Do not use sharp or pointed objects to accelerate the defrosting process.
P
P +
+
P
-
-
DEF
To Next Page
Loading...
Need help?
General
