Grand-Pro A1 - Remote Controller Guide; Remote Control Operation

Introduction
Start
Front
Left
Back
Right
Stop
Random Clean Mode
Random Clean Mode
“Z” Clean Mode
“Z” Clean Mode
Mop Mode
Mop Mode
Edge Clean Mode
Edge Clean Mode
Fan
Fan
Charge
Charge
Spiral Clean Mode
Spiral Clean Mode
Remote Controller Introduction
Number
Description
Start
Front
Left
Right
Stop
Back
Press start to enter automatic clean mode.
Press once, the robot will move front. It will move back for 3.9in if it gets
stopped by obstacles.
Press once or long press to move left.
Press once or long press to move right.
Press once or long press, the robot will move back for 8 inches. Notice that there
is no anti-drop sensor on the back of the robot, so please mind the steps when
you control it to move back.
Press once to stop.
The robot will enter random clean mode.
The robot will clean against wall.
The robot will spin in circles to clean, use this function for Main cleaning area.
The robot will clean with “Zig-Zag” pattern.
The robot will immediately enter mopping mode once this button
is pressed.
The robot will immediately enter vacuuming mode once this button is pressed.
The robot will immediately go back to docking station to charge once this
button is pressed.
1. The robot will clean with the clean mode you choose.
2. When the robot is charging on the docking station,press “Start”
to let it leave the docking station and then clean the room according
to the mode you choose.
RemoteController
3