Always Ring
Speaker
Configures enabling/disabling the speaker to ring when the headset is used on "Toggle Headset/Speaker" mode. it
can be set to "No", "Yes, Both" or "Yes, Speaker Only",
The Default Value is "Yes, Both"
Group Listen
with handset
Allow handset to be able to listen when picked up during a call with headset.
Disabled by Default.
Group Listen
with Speaker
In a call, phone will display soft key to enable speaker listening when audio mode handset or headset.
Disabled by Deafult.
Headset TX Gain
(dB)
Configures the transmission gain of the headset.
The default value is 0dB.
Headset RX Gain
(dB)
Configures the receiving gain of the headset.
The default value is 0dB.
Enable Headset
Noise Shield 2.0
When enabled, the remote party will not hear the environmental noise during a call using the headset. Choose
according to the TX loudness of the earphone. When the TX loudness of the headset is loud, please select the "Loud
Headset", and when the TX loudness of the headset is soft, please select the "Thin Headset". "Moderate Headset" is
selected by default.
Handset
Handset TX Gain
(dB)
Configures the transmission gain of the handset.
Enable Handset
Noise Shield 2.0
When the Handset Noise Shield feature is enabled, the remote party will hear less environmental noise during a call.
If set to "High Shielding", most of the environmental noise can be shielded. If set to "Soft Shielding", some
environmental comfort noise will remain for the remote party.
The Default Value is "High Shielding"
Handset Sidetone
Volume
Configures Handset sidetone volume. The valid range is 0 to 30.
The Default value is 15.
Enable HAC
if enabled， the phone will compatible with nearby hearing AIDS.
Disabled by Default.
System Settings 🡪 Energy Saving
Instantaneous
energy saving
ratio
Shows a live energy-saving ratio preview based on the energy-saving mode selected.
Usage Displays the Deep energy saving duration relative to the phone's enabling duration
Energy saving
Displays a diagram of energy spent in MWh throughout the phone’s activity period.
By default, it shows a comparison between the energy spent in the current day and the day before.
Energy Saving
Master Control
● When configured at Standard Mode, the device will behave as it has been prior to addition of the Energy Saving
Control feature. All energy related features will function according to the individual configurations.
● When configured at Customized Energy Saving Mode, the device will enable relevant energy-saving measures
and support users to operate some basic configuration items.
● When configured at Maximum Energy Saving Mode, the device will ignore all individual configurations and use
the setting that will maximize energy saving. No customization is possible under this mode.
Note: in the Customized Energy Saving mode, if the configured idle LCD brightness is greater than active LCD
brightness , an error message will be displayed.
By default set to "Standard Mode".
To Next Page
Loading...
