Grandstream Networks GRP261 Series Administration Guide

P a g e | 97
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
Maintenance Page Definitions
Table 14 : Maintenance Page Definitions
Maintenance  Web Access
User Password
New Password
Set new password for web GUI access as User. This field is case sensitive.
Confirm Password
Enter the new User password again to confirm.
Admin Password
Current Password
The current admin password is required for setting a new admin password.
New Password
Set new password for web GUI access as Admin. This field is case sensitive.
Confirm Password
Enter the new Admin password again to confirm.
Maintenance  Upgrade and Provisioning
Firmware Upgrade
and Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
The default setting is “Always Check for New Firmware”.
Always Authenticate
Before Challenge
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials
before being challenged by the server. The default setting is “No”.
Validate Hostname
in Certificate
Allows to validate the hostname in the SSL certificate.
The default setting is “No”.
Allow DHCP Option
43 and Option 66
Override Server
DHCP option 66 originally was only designed for TFTP server. Later on, it was
extended to support an HTTP URL. GRP phones support both TFTP and HTTP
server via option 66. Users can also use DHCP option 43 vendor specific
option to do this.
DHCP option 43 approach has priorities. The phone is allowed to fall back to
the original server path configured in case the server from option 66 fails.
The default setting is “Yes”.
Additional Override
DHCP Option
When enabled, users could select Option 150 or Option 160 to override the
firmware server instead of using the configured firmware server path or the
server from option 43 and option 66 in the local network. Please note this
option will be effective only when option “Allow DHCP Option 43 and Option
66 to Override Server” is enabled. The default setting is “None”.
Allow DHCP Option
120 to override SIP
Server
Enables DHCP Option 120 from local server to override the SIP Server on the
phone. The default setting is “No”.
3CX Auto Provision
Enables automatic provisioning feature (PNP) on the phone when 3CX is used
as the SIP server. The default setting is “Yes”.
Automatic Upgrade
Enables automatic upgrade and provisioning.
The default setting is “No”.

Grandstream Networks GRP261 Series Specifications

General

Brand	Grandstream Networks
Model	GRP261 Series
Category	IP Phone
Language	English