1. Click on “Call routing” in the left hand column. This will automatically
load the Call routing Profile Page (See Figure 9-1). On this page you
can configure the call routing for internal, inbound and outbound calls.
2. Click on “Internal call” to configure the rules for internal calls between
extensions and feature codes.
Note: The GXE configure automatically the internal call profile while doing
the express setup.
3. Click on “General Inbound” to configure the route of the incoming calls
for all trunks (PSTN, SIP and Peers).
Note: by default the GXE route all the incoming calls to the default auto
attendant.
4. Click on “General Outbound” to configure the route of the outgoing calls
by using a static prefix or country code … Please visit the help section
on the Call routing page for more information.
Figure 9-1
To Previous Page
Loading...
Need help?
General
