3.
Check or uncheck the option for Wi-Fi.
Or, users could open the top status bar and tap on WI-FI icon to turn it on/off.
Connect to Wi-Fi Networks
1.
Once Wi-Fi is turned on, GXV34x0 will automatically start the scanning within the range.
2.
Go to GXV34x0’s Settings.
3.
Touch Network.
4.
Touch Wi-Fi Settings.
5.
A list of Wi-Fi networks will be displayed as scanning result. Tap on the SSID and enter the correct password information
to connect to the selected Wi-Fi network.
6.
The phone will start connecting to the Wi-Fi. The status bar will show Wi-Fi signal strength.
7.
Once it’s added and the password is remembered, the GXV34x0 will connect to it again when the SSID is within the range.
Figure 169: GXV34x0 Connect to Wi-Fi
8.
The previous steps allow the GXV34x0 to connect the Wi-Fi network with DHCP setting by default. If it needs to be
connected the Wi-Fi with static IP settings, please scroll down the setting window and tap to check the “Show advanced
options”. Then the window will show up the IP settings at the bottom. If the Static is selected, the system will require end
user to input IP address, Gateway, Network prefix length and DNS 1 and DNS 2 addresses.
To Next Page
Loading...
Need help?
General
