P a g e | 47
GXW42xx User Manual
Version 1.0.15.30
Table 9: Advanced Settings
Configuration option for all FXS ports ring cadence for all incoming calls.
(Syntax: c=on1/off1-on2/off2-on3/off3; [...]) Default is set to c=2000/4000; (US
standards)
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies. Frequencies
should be configured with known values to avoid uncomfortable high pitch sounds. ON
is the period of ringing (ON time in ms) while OFF is the period of silence. In order to
set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern.
• “Dial tone”
• “Ring back tone”
• “Busy tone”
• “Reorder tone”
• “Confirmation tone”
• “Call-Waiting tone”
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Enable or disable the Failover FXO Gateway.
IP Address or URI of the FXO gateway.
Disables the Direct IP Call function. Default is “No”. If set to “Yes” direct IP-to-IP calling
will not be supported.
Disable SIP
NOTIFY
Authentication
Disables challenging SIP NOTIFY reboot and resync messages.
Disables the voice prompt configuration. Default is “No”. If set to “Yes” accessing
integrated voice menu will be impossible.
Choose English, Chinese, or Spanish.
To Next Page
Loading...
Need help?
General
