P a g e | 8
GXW42xx User Manual
Version 1.0.15.30
Added the option to enable/disable [Authenticate server certificate domain].
Added the option to enable/disable [Authenticate server certificate chain].
Added the option to configure [Trusted CA certificates].
Added the function of [Automatic Reboot].
Added the option to [Allow DHCP Option 42 to NTP Server] to support Time and Date settings.
Added the option to [Allow DHCP Option 2 to override time zone] to support Time and Date settings.
Added the option to enable/disable [3CX Auto Provision] to support multicast SUBSCRIBE for provision.
Firmware version 1.0.5.8
Added option [SIP REGISTER Contact Header Uses] [Use Request Routing ID in SIP Headers] for
Profile 1-4 to support NAT transfer feature.
Firmware version 1.0.5.5
Added option [Enable Fast RFC2833] to set DTMF duration by RFC2833.
Added SNMP support. Added [SNMP] section.
Added QoS settings for SIP and RTP packets. Rearranged options [Layer 2 QoS Settings] and [Layer
3 QoS Settings].
Added star code [*98] to play registration ID
Added star code [*99] to trigger provisioning process.
Added support to download device configuration file.
Firmware version 1.0.4.22
Added support for audio codec G.722
Added option [Always send HTTP Basic Authentication Information] to enable sending HTTP
authentication without server challenge
Added the options to enable/disable [Use P-Preferred-Identity Header] and [Use Privacy Header]
Added the options to enable/disable [Do Not Escape '#' as %23 in SIP URI]
Firmware version 1.0.4.17
Added option [Use Request Routing ID in SIP Headers] to enable/disable device to use configured
Request URI Routing ID for certain FXS port in its SIP message Header when a trunk SIP account is
used.
Added option [Add Auth Header on Initial REGISTER] to enable/disable including authentication header
in the initial REGISTER.
To Next Page
Loading...
Need help?
General
