When changing any settings, always submit them by pressing the Update or Apply button on the bottom
of the page. After submitting the changes in all the Web GUI pages, reboot HT801/HT802 to have the
changes take effect if necessary; most of the options under the Advanced Settings and FXS Port (x)
pages require reboot.
Saving the Configuration Changes
After users makes changes to the configuration, pressing the Update button will save but not apply the
changes until the Apply button is clicked. Users can instead directly press the Apply button. We
recommend rebooting or powering cycle the phone after applying all the changes.
Changing Admin Level Password
1. Access your HT801/HT802 web UI by entering its IP address in your favorite browser
(screenshots below are from HT802 but the same applies to HT801).
2. Enter your admin password (default: admin).
3. Press Login to access your settings and navigate to Advanced Settings > Admin Password.
4. Enter the new admin password.
5. Confirm the new admin password.
6. Press Apply at the bottom of the page to save your new settings.
Figure 7: Admin Level Password
Changing User Level Password
1. Access your HT801/HT802 web UI by entering its IP address in your favorite browser.
2. Enter your admin password (default: admin).
3. Press Login to access your settings and navigate to Basic Settings > End User Password.
4. Enter the new user password.
5. Confirm the new end-user password.
6. Press Apply at the bottom of the page to save your new settings.
Figure 8: User Level Password
To Next Page
Loading...
Need help?
General
