FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 24 of 46
Default is HT7XX. Used by clients and servers to exchange vendor-specific information..
Controls how the date/time is displayed according to the specified time zone.
The syntax is std offset dst [offset],start[/time],end[/time]
Default is set to : MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
Time zone with 6 hours offset with 1 hour ahead which is the US central time. It is positive
(+) if the local time zone is west of the Prime Meridian and negative (-) if it is east.
Prime Meridian (a.k.a: International or Greenwich Meridian)
M3.2.0,M11.1.0
The 1
st
number indicates Month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
The 2
nd
number indicates the n
th
iteration of the weekday: (1st Sunday, 3rd Tuesday etc)
The 3
rd
number indicates Weekday: 0,1, 2, ..,6(for Sun, Mon, Tue, .., Sat)
Therefore, this example is the DST which starts from the second Sunday of March to the
1st Sunday of November.
Allow DHCP server to
set Time Zone
Default Yes. Let the DHCP server handle the Time Zone
Languages supported with voice prompt and web interface, except Spanish that it is only
in IVR.
Gives the user the option to set to default all VoIP related configuration (mainly everything
located on FXS/Profile page), all ISP (Internet Service Provider) configuration which may
affect the IP address, or both at the same time.
Note: After you choose the reset type, you will have to click the reset button for it to take
effect.
In addition to the Basic Settings configuration page, end users also have access to the Device Status
page.
TABLE 8: STATUS PAGE
The device ID, in HEX format. This is very important ID for ISP troubleshooting. The Mac
address will appear in this place. The MAC address will be used for provisioning and can
be found on the label coming with original box and on the label located on the bottom
panel of the device.
To Next Page
Loading...
Need help?
General
