We recommend users to consider the following options for added security when deploying the WP810 with
provisioning.
- Upgrade Via: HTTPS:
By default, HTTPS is selected. This is recommended so the traffic is encrypted while travelling through
the network.
- HTTP/HTTPS/FTP/FTPS User Name and Password:
This can be set up as required on the provisioning server when HTTP/HTTPS/FTP/FTPS is used. Only
when the WP810 has the correct username and password configured, it can be authenticated by the
Upgrade/provisioning server and the config file can be downloaded.
- Authenticate Config file:
This sets the WP810 to authenticate the configuration file before applying it. When set to “Yes”, the
configuration file must include P value P1 with WP810 system’s administration password. If it is missed
or does not match the password, the WP810 will not apply the config file.
- XML Config File Password:
The WP810 XML config file can be encrypted using OpenSSL. When it’s encrypted, the WP810 must
supply the correct password in this field so it can decrypt XML configuration file after downloading it.
Then the configuration can be applied. Please note this feature is supported on XML config file instead
of the binary config file. Therefore, it’s recommended to use XML config file format and encrypt it with
this feature.
- Validate Server Certificates: (under Maintenance → Security settings → Security)
This configures whether to validate the server certificate when downloading the firmware/config file. If
set to "Yes", the WP810 will download the firmware/config file only from the legitimate server.
TR-069
TR-069 is enabled by default, it’s recommended to disable it if not used.
When TR-069 is enabled under Maintenance → TR-069, and the service is to be used, users can set up
the following:
• ACS URL: Specifies URL of TR-069 Auto Configuration Servers.
• ACS Username/Password: Enters username/Password to authenticate to ACS.
• Periodic Inform Enable: Sends periodic inform packets to ACS.
• Periodic Inform Interval: Sets frequency that the inform packets will be sent out to ACS.
• Connection Request Username/Password: Enters username/Password for ACS to connect to
To Next Page
Loading...
Need help?
General
