GRAPHTEC gl200a - 3.5 Replacing the Control Panel Board

GL200-UM-251-9370 3-4
3. DISASSEMBLY AND REASSEMBLY
3.5 Replacing the Control Panel Board
Disassembly
(1) Remove the side pads from the main unit (See Section 3.2).
(2) Disassemble the top cover assembly and the bottom case assembly (See Section 3.3).
(3) Remove the main control board (See Section 3.4).
(4) Remove the four M2L5 self-tapping screws holding the control panel board from the top cover assembly.
(5) Remove the control panel board from the top cover assembly.
Top cover assembly
Control panel board
M2L5 self-tapping screw
Re-assembly
(1) Re-assemble the control panel board in the reverse order in which it was disassembled.