GRAPHTEC gl200a - 5. INSPECTION AND CHECK PROCEDURES; 5.1 Inspection and Check Methods

GL200-UM-251-9370 5-1
5. INSPECTION AND CHECK PROCEDURES
5. INSPECTION AND CHECK PROCEDURES
5.1 Inspection and Check Methods
Preparations for inspections and checks
Condition settings file :GL2CondVT.CND ← Condition settings for measurement accuracy
(1) Copy the condition settings file to a USB memory device from the computer.
How to load the condition settings file to the GL200A from a USB memory device
(1) Press the [FILE] key, and then move the cursor to the “Load” position using the [Direction] keys.
(2) Press the [ENTER] key to display the menu below.
(3) Move the cursor to the “File Name” position using the [Direction] keys.