GRAPHTEC gl200a - 3.6 Replacing the LCD

GL200-UM-251-9370 3-5
3. DISASSEMBLY AND REASSEMBLY
3.6 Replacing the LCD
Disassembly
(1) Remove the side pads from the main unit (See Section 3.2).
(2) Disassemble the top cover assembly and the bottom case assembly (See Section 3.3).
(3) Remove the main control board (See Section 3.4).
(4) Remove the M2L5 self-tapping screw holding the LCD bracket and the LCD from the top cover
assembly.
(5) Remove the LCD from the top cover assembly.
Top cover assembly
LCD Bracket
LCD
M2L5 self-tapping screw
Re-assembly
(1) Re-assemble the LCD in the reverse order in which it was disassembled.