GL820-UM-251-9370 4-9
4. SETUP PROCEDURES
Setup procedure
(1) As shown in the gure above, connect the inputs of the zero controller to the GL820’s input terminals.
(2) Leave the GL820 turned on for at least 30 minutes. And leave the GL820 turned on for at least 10
minutes after wiring.
(3) After entering the System Setup mode, open the Setup menu as shown below.
Specify the AMP Setup conditions as shown below.
Mode :Setup2 (Room temp.)
Sensor :Sensor1
Area :Area1
CH :CH 1
(4) Move the cursor to the “Execute Setup” position as shown below.
To Next Page
Loading...
