GL820-UM-251-9370 4-10
4. SETUP PROCEDURES
(5) Press the [ENTER] key to start the Setup2 (Room temp.) operation.
Message
(6) The “rTemp : [START]” message is displayed at the location shown above.
(7) Press the [START] key and then wait until the "EEPROM : [ENTER]" message appears.
Message
(8) Press the [ENTER] key to begin writing the new Setup data to the EEPROM.
(9) After the setup parameters have been registered to the EEPROM, the display closes and returns to
normal mode.
To Next Page
Loading...
