GL820-UM-251-9370 4-11
4. SETUP PROCEDURES
(10) Re-open the Setup menu as shown below.
Specify the AMP Setup conditions as shown below.
Mode :Setup2 (Room temp.)
Sensor :Sensor1
Area :Area2
CH :CH 1
(11) Repeat steps (4) to (8) for all the areas up to Area 4.
(12) Turn off the GL820.
This completes the Room temp. setup.
Setup ow for the Room temp.
Procedure Selected area
1 Area 1
2 Area 2
3 Area 3
4 Area 4
To Next Page
Loading...
