GRAPHTEC GL980 - Page 14

13
Displays the alarm output status.
The number with which an alarm went off is displayed in red. The channel with the alarm threshold has a red input
value in the digital display area.
Displays the Y-T waveform of the input signal.
(The vertical axis is measured value and the horizontal axis is time.)
(1) During data capture
A file name is displayed during the recording.
* If the ring capturing setting is ON, a file name displayed during capture ends with "_RINGx" (x represents a
number) but the actual file name does not include "_RINGx".
In the above figure, if the ring capturing is set to ON, the file name during capture will be displayed, for
example, as "<MEM>170711\PREFIX_170711-130955_RING4.GBD" but the actually created file will be
"<MEM>170711\PREFIX_170711-130955.GBD".
* For details, refer to “3.5 Setting Menus” - “(2) DATA settings”.
(2) During data replay
Information on the time axis of the cursor is displayed during Y-T replay.
(1) During data capture
A capture file name is displayed during capture.
Displays the each channel signal position, trigger position and alarm range.
Displays the scale upper/lower limit of the currently active CH.
Trigger position Alarm range
Stop position
Start position
Rising Falling Win In Win Out
Time to which the cursor points
Selected cursor
Time difference between Cursors A and B
Elapsed time Remaining time for data capture
Used capacity of internal memory, SD
card and USB memory
Remaining capacity of internal memory, SD
card and USB memory
Total capacity of internal memory, SD card and USB memory
Alarm display area
Level bar
File name display area
Scale upper/lower limit
Waveform display area
Data capture bar
14.
15.
16.
17.
18.
19.