GRAPHTEC midi LOGGER GL220 - Setup: How to Make the Settings

TIME/DIV
QUIT
MENU
ENTER
CURSOR
REVIEW
DISPLAY
START
STOP
FILE
SPAN/POSI/TRACE
TIME/DIV
QUIT
MENU
ENTER
CURSOR
REVIEW
DISPLAY
START
STOP
FILE
SPAN/POSI/TRACE
2. Setup: How to Make the Settings
2.A selection menu is displayed when
the ENTER key is pressed. Use the
and keys to select "TEMP."
3. Press the ENTER key to confirm your
selection.
1. Press the MENU key to display the setup menu screen.
2. Set Input to "TEMP" and Range to "TC-T" for CH1,
and set Input to "DC" and Range to "1V" for CH2.
(1) Move the cursor to CH1 "Input" and select "TEMP" and then move it
to "Range" and select "TC-T."
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
then move it to "Range" and select "1V."
3. Select "Off" for all the other channels.
(1)Using the procedure described above, select "Off" for CH 3 to CH 10.
Make the settings required for data capture. Here we will make only those settings that are
minimum requirement. The other settings will be not changed from the factory default settings.
Basic Setup Menu Operation
- Examples of selection menu operations (AMP screen)
1. Use the keys to move the
cursor to the Input parameter of
CH 1 and then press the ENTER key.
The key, the ENTER key, and the QUIT key are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green. Use the keys
to move the cursor. If you press the ENTER key at the cursor position, a selection menu or a box
of entering value for selected item is displayed. If you press the QUIT key, the screen closes
and the settings are canceled.
Points to
Remember !
(Note: Select "DC" for voltage measurement, and "Humidity" for humidity measurement.)
10
to "Range" and select "TC-T."
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
to "Range" and select "TC-T."
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
to "Range" and select "TC-T."
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
(1)Using the procedure described above, select "Off" for CH 3 to CH 10.