1. Starting data capture
(1) Press the START/STOP key.
(2) A confirmation message is displayed.
(3) Press the ENTER key to start data capture.
2. Screen status during data capture
Once data capture has started, progress of data capture is shown. The displayed
time is counting up or down.
3. Stopping data capture
Press the START/STOP key to end the data capture operation.
(1) Press the START/STOP key.
(2) A confirmation message is displayed. Press the ENTER key.
(3) Data capture ends, and the GL220 goes into the Free Running status.
The operation of data capture is completed.
3. Data Capture: How to Capture Data
All of setting for the data capture have been set, capturing data can be started now.
During the data capture operation, let's also replay some data that was captured previously.
elapsed time
capturing message
remaining time for data capture
(
The indication becomes ++++ when the data capture time is 9999 hours or more.)
13
(2) A confirmation message is displayed.
(3) Press the ENTER key to start data capture.
(1) Press the START/STOP key.
(1) Press the START/STOP key.
(2) A confirmation message is displayed. Press the ENTER key.
(2) A confirmation message is displayed. Press the ENTER key.
The indication becomes ++++ when the data capture time is 9999 hours or more.)
The indication becomes ++++ when the data capture time is 9999 hours or more.)
Data can be replayed while being captured by pressing the REVIEW key. Data
can be replayed during the data capture operation from the beginning to the
point that has been captured. During the replay, you can check arbitrary level
values and such by moving the cursor. You can return to the data capture
screen by pressing the REVIEW key again.
Points to
Remember !
REVIEW
To Next Page
Loading...