GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Ident-Nr. 0057999
Made in Thailand
04/2003
72
72
Recommended servos and RC components:
For nosewheel steering and 2 x C 4041, Order No. 3916
speedbrake or
2 x C 5077, Order No. 4103
For elevons 4 x DS 8411, Order No. 5151
or
4 x C 4421, Order No. 3892
or
4 x C 4621, Order No. 5126
or
4 x DS 8231, Order No. 5155
For rudders 4 x DS 8411, Order No. 5151
or
2 x C 4421, Order No. 3892
or
2 x C 4621, Order No. 5126
or
2 x DS 8231, Order No. 5155
For thrust vectoring control 1 x DS 8411, Order No. 5151
or
1 x C 4621, Order No. 5126
or
1 x DS 8231, Order No. 5155
For retracts and brake 2 x C 261, Order No. 5125
(for mechanical valves)
2 x electronic pneumatic valve, Order No. 5171
For coupled rudders / 2 x Y-lead, Order No. 3936.11
steerable nosewheel; or
also for linking elevons; 1 Magic-Box, Order No. 3162
one per wing panel 2 Magic-Box, Order No. 3162
Receiver switch Power switch harness, Order No. 3050
Receiver battery Minimum capacity 2400 mAh
You will probably find that the standard servo leads are not long enough, in which case you should use the
recommended extension leads which are listed in the main catalogue. The building instructions do not state exact
cable types, as the lengths required will vary according to the location of the receiver and the way you deploy the
cable looms in the fuselage. A better solution is our Magic-Box, Order No. 3162, as it allows adjustment of servo
travels and neutral point for each servo connected to it (max. four servos).
Servo extension leads will also be required for the functions in the fuselage: between 750 mm, Order No.
3935.75, and 1050 mm, Order No. 3935.105 (four each). A further servo extension lead, Order No. 3935.11, is
required to connect each outboard wing servo (two required: one in each wing). We strongly recommend that
you incorporate folding ferrite rings, Order No. 98516 or 98516.1, into the thick cable looms.
If you wish to use other makes of servo please note that they must offer similar levels of torque and holding
power to the types we recommend.
If you intend to install a jet engine with a rated thrust of more than 8 kg, you
must
replace the standard
wing joiner tube with the carbon fibre joiner rod, Order No. 6264.220.
Accessories (not included in the kit)
Complete retract set, Order No. 175, or retract mechanism, Order No. 174, in conjunction with the trailing-axle
spring struts, Order No. 174.1
GRP fueltank, Order No. 130, or PET disposable bottle
Wide range of RC components, servo extension leads, Magic-Boxes
Turbine and turbine accessories
Electronic valves, Order No. 5171
Epoxy resin
Cyano-acrylate activator spray
Carbon fibre wing joiner rod, Order No. 6264.220
To Next Page
Loading...
