GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors! 3/2012
2
Please be sure to observe the safety instructions in the appendix of these assembly
instructions. If the model is given to another person then the complete assembly instructions
must be given along with the model as a reference.
General
The SUPER DECATHLON model is a particularly attractive semi-scale model
equipped with many authentically replicated details. The model is extensively
prefabricated. However, the assembly steps described below are to be carried out
with great care in order to ensure the safe and successful implementation of the
model. Flying weight may not exceed 1700 g.
RC accessories (not included)
MX-16 COMPUTERSYSTEM 2.4 GRAUPNER HoTT Order no. 33116
Charger, ULTRAMAT 8 Order no. 6411
LiPo battery, 20C 3/2500 11.1 V G3.5 Order no. 7633.3
Charger cable, G3.5 Order no. 2970.L
Receiver battery (for position lights) Order no. 2583
BEC adapter lead (for position lights) Order no. 3029.10
Velcro ribbon Order no. 3368.1
Float set Order no. 9399.15
Necessary tools and adhesives
(not included)
Fast setting glue Order no.5821
Activator for fast setting glue Order no. 953.150
Also needed: Phillips screwdriver, flat pliers, scissors, 1.5 mm Allen wrench, pulp-
fiber paper, protective gloves, safety goggles
Assembly instructions
Please read the assembly instructions thoroughly before starting with assembly in
order to gain an overview of the assembly process. For each assembly step, remove
the parts needed from their transparent packages and gather the necessary tools
and adhesives. Assembly work should always be done on a clean, flat surface or on
a foam-rubber pad. When not otherwise specified, use fast setting glue with activator
as an adhesive. The best technique is to coat one surface with glue and spray
activator on the other surface. One should be particularly careful that no glue residue
gets onto one's hands or on the model's exterior surfaces. Fast setting glue and
activator spray dissolve paint on surfaces so do not use too much glue. If necessary,
dab off excess glue right away with pulp-fiber paper.
Attention: Fast setting glue must never come into contact with human body
parts or get into eyes. Because of this we recommend that safety goggles be
worn when working with glue. Always store the glue out of the reach of
children. For reasons of safety, use only the above named glue.
To Next Page
Loading...
