EN - 25
Replace Relay
NOTICE: Relays are interchangeable. Use
only quality replacement parts. See Service
Parts on page 17.
1. Place unit in service position. See
Service Position on page 16.
2. Remove defective relay.
3. Determine cause of relay failure and
repair condition.
4. Install new relay.
REPLACE PTO BELT
1. Place unit in service position. See
Service Position on page 16.
2. Position mower deck at lowest cutting
height.
See Figure 30.
3. Loosen wing knobs securing belt covers
to deck and remove belt covers.
4. Lift foot plate to access deck center.
Remove PTO Belt
See Figure 31.
1. Slowly remove spring hook from anchor
bolt to release tension from belt idler.
2. Remove PTO belt.
CAUTION: Damage or worn
belts may result in injury and / or
damage to the unit. Check belts
for excessive wear or cracks of-
ten.
CAUTION: Use care when
releasing idler spring tension.
Keep body parts away from
idlers when performing this
operation.
1
4
3
2
1. Spring
2. Anchor Bolt
3. PTO Belt
4. PTO Belt Idler
Figure 31
To Next Page
Loading...
