To Next PageTo Next PageWhat to do if my Gravely Lawn Mower engine runs when off?
If your Gravely Lawn Mower engine continues to run when the ignition key is in the off position, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean metal surface.
What to do if my Gravely Lawn Mower engine does not crank?
If your Gravely Lawn Mower engine doesn't crank, several issues could be the cause. Here are a few things to check: * Ensure the PTO is disengaged. * Make sure the parking brake is engaged. * Inspect battery cables for looseness or corrosion; clean and tighten them if needed. * Check the battery charge level; charge if necessary. * Inspect the main fuse and replace it if it's blown. * Check the relays in the fuse block and replace if necessary. * Examine the wire harness and connections for loose or broken wires.
General| Engine Brand | Kawasaki |
|---|---|
| Cutting Width | 52 inches |
| Transmission | Hydro-Gear ZT-3100 |
| Engine Displacement | 726 cc |
| Deck Type | Fabricated |
| Deck Material | Steel |
| Cutting Height | 1.5 - 5 in |
| Deck Lift | Foot-operated |
| Warranty | 2 years |
Explanation of safety alert symbols, signal words, and decal locations.
Essential safety rules, operator training requirements, age, and child safety.
Guidelines for personal protective equipment and pre-operation inspections.
Procedures for safe operation including controls, interlocks, and general conduct.
Precautions and limitations for operating the unit on slopes.
Critical safety instructions for handling gasoline and refueling.
Safety precautions related to towing, accessories, and battery handling.
Step-by-step instructions for setting up the unit before initial use.
Explanation and testing of safety interlock and parking brake systems.
How to operate the steering levers for control of speed and direction.
Instructions for safely fueling the unit and approved gasoline types.
Essential checks to perform before starting the engine.
How to stop the unit in an emergency and procedures for mowing.
Routine checks and cleaning required before or after each use.
Instructions for checking and changing the engine oil.
Steps for adding, checking, and changing hydraulic fluid and filter.
Procedure for purging air from the hydraulic system.
Guide on how to properly sharpen mower blades for optimal performance.
Procedures for removing, replacing, cleaning, and charging the battery.
Procedure for leveling the mower deck side-to-side and front-to-back.
Checking blade level, pitch, and adjusting blade height.
Diagnosing and correcting issues related to engine cranking and starting.
