To Next PageTo Next PageWhy does my Gravely Pro-Turn 460 EFI move with the engine off and parking brake on?
If your Gravely Lawn Mower moves even with the engine off and the parking brake engaged, the parking brake likely needs adjustment. Adjust the parking brake lever.
Why does my Gravely Pro-Turn 460 EFI engine not crank?
If your Gravely Lawn Mower engine won't crank, it might be due to several reasons. First, make sure the PTO is disengaged. Next, engage the parking brake. Check for loose or corroded battery cables, and if found, clean and tighten them. Also, verify if the battery is discharged and charge it if necessary.
What to do if the Gravely Lawn Mower engine continues to run when the key is off?
If the engine continues to run when the ignition key is in the off position on your Gravely Lawn Mower, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean metal surface.
Why is my Gravely Lawn Mower engine running rough?
A rough-running engine in your Gravely Lawn Mower can stem from several causes: * If your model is 992273, 992274, 992275, or 992276, ensure the choke control lever is disengaged. * Check if the fuel tank is empty and fill it if needed. * A faulty spark plug, dirty fuel filter, or plugged air filter cartridge can also cause this issue, so replace or clean them as necessary. If none of these steps improve engine performance, the engine itself may be faulty, and it's best to contact your Gravely dealer.
How to improve the cutting quality of my Gravely Lawn Mower?
To enhance the cutting quality of your Gravely Lawn Mower, consider the following: * Level and adjust the pitch of the mower deck. * Sharpen or replace dull or faulty mower blades. * Reduce mowing speed, especially in tall grass. * Inspect and replace the PTO belt or mower drive belt if their tension or condition is poor. * Avoid setting the cutting height too low; for very tall grass, mow twice.
Why is my Gravely Pro-Turn 460 EFI Lawn Mower engine overheating?
If your Gravely Lawn Mower engine is overheating, it could be due to: * Low engine oil level, so add engine oil. * Plugged cooling fins, so clean the engine. If the problem persists after these steps, the engine itself may be faulty, and you should contact your Gravely dealer.
General| Cutting Width | 60 inches |
|---|---|
| Transmission | Hydro-Gear ZT-5400 |
| Spindle Material | Cast Iron |
| Ground Speed (Forward) | 13 mph |
| Ground Speed (Reverse) | 6 mph |
| Deck Type | Fabricated |
| Turning Radius | Zero-turn |
| Cutting Height | 1.0 - 5.5 in |
| Engine | Kawasaki FX850V EFI |
| Warranty | 5 years or 1500 hours (whichever occurs first) |
Warning and precautions for amputation hazards.
Warning and precautions for discharge hazards.
Warning and precautions for tipping hazards.
Safety during unit servicing.
Safety concerning bystanders.
Hazards related to loss of traction.
Warnings about rotating parts.
Precautions for hot engine parts.
Key safety rules for operation.
Importance of understanding operation and safety.
Safety measures to protect children.
Pre-operation checks and safety.
Safety guidelines for operating on slopes.
Precautions for handling gasoline and fuel.
Safety precautions during maintenance and service.
Instructions for assembling the seat.
Procedure for adjusting steering levers.
Diagram showing location of various controls and features.
Numbered list of all controls and features.
Step-by-step guide to starting the engine.
Initial operation and steering control.
Recommended service intervals for the unit.
Adjusting transaxles for excessive creep.
Adjusting parking brake interlock.
Ensuring the unit drives in a straight line.
Procedures for replacing mower belts.
Procedures for replacing the transaxle drive belt.
Steps to remove the mower deck.
Steps to install the mower deck.
Checking blade level and pitch.
Adjusting deck to be level.
Adjusting the pitch of the mower blades.
Issues related to the engine not starting.
Problems with the engine running rough or overheating.
Issues with the unit not driving or driving straight.
Problems with PTO operation or cut quality.
