To Next PageTo Next PageWhat causes a Gravely Pro-Turn 472 EFI engine to run when the ignition key is off?
If your Gravely Lawn Mower engine continues to run even when the ignition key is in the off position, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean, metal surface.
What does it mean when the malfunction indicator light is illuminated on my Gravely Pro-Turn 472 EFI?
If the malfunction indicator light is illuminated on your Gravely Lawn Mower (Models 992278, 992279, 992282, 992283, 992284, 992288, 992289, 992290), it means the system has detected an engine malfunction. Stop the engine immediately.
What should I do if the oil pressure light is on in my Gravely Pro-Turn 472 EFI Lawn Mower?
If the oil pressure light is illuminated on your Gravely Lawn Mower, it indicates low oil pressure. Stop the engine immediately.
Why does my Gravely Pro-Turn 472 EFI creep when the steering levers are in neutral?
If your Gravely Lawn Mower creeps forward even when the steering levers are in the neutral position, it could be due to transaxles needing adjustment or the parking brake interlock requiring adjustment.
What causes a Gravely Pro-Turn 472 EFI Lawn Mower engine to keep running after turning the key off?
If your Gravely Lawn Mower's engine continues to run after you've turned the ignition key off, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean, metal surface. If this doesn't solve the issue, the ignition switch may be faulty, and you should contact your Gravely dealer.
Why is my Gravely Pro-Turn 472 EFI engine overheating?
If your Gravely Lawn Mower engine is overheating, it could be due to: * Low engine oil level, so add engine oil. * Plugged cooling fins, so clean the engine. If the problem persists after these steps, the engine itself may be faulty, and you should contact your Gravely dealer.
How to improve the cutting quality of my Gravely Pro-Turn 472 EFI Lawn Mower?
To enhance the cutting quality of your Gravely Lawn Mower, consider the following: * Level and adjust the pitch of the mower deck. * Sharpen or replace dull or faulty mower blades. * Reduce mowing speed, especially in tall grass. * Inspect and replace the PTO belt or mower drive belt if their tension or condition is poor. * Avoid setting the cutting height too low; for very tall grass, mow twice.
Why is my Gravely Pro-Turn 472 EFI Lawn Mower engine running rough?
A rough-running engine in your Gravely Lawn Mower can stem from several causes: * If your model is 992273, 992274, 992275, or 992276, ensure the choke control lever is disengaged. * Check if the fuel tank is empty and fill it if needed. * A faulty spark plug, dirty fuel filter, or plugged air filter cartridge can also cause this issue, so replace or clean them as necessary. If none of these steps improve engine performance, the engine itself may be faulty, and it's best to contact your Gravely dealer.
Why does my Gravely Pro-Turn 472 EFI move with the engine off and parking brake on?
If your Gravely Lawn Mower moves even with the engine off and the parking brake engaged, the parking brake likely needs adjustment. Adjust the parking brake lever.
Why won't my Gravely Lawn Mower engine start?
Your Gravely Lawn Mower engine might not start due to several reasons. The PTO switch may be in the on position, so push it down to the off position. Ensure the parking brake is engaged. Check if the fuel tank is empty and fill it if needed. Contaminated fuel can also prevent starting, so replace it with clean fuel. A discharged battery needs charging. Clean and tighten any loose or corroded battery cables. Also, make sure the safety interlock system is properly engaged and not faulty.
Welcome message, product registration, and manual details.
Safety rules, alert symbols, training, and operational precautions.
Overview of controls, starting, operating, and emergency procedures.
Maintenance schedule, key adjustments, fluid system service, and repairs.
Troubleshooting guide for engine, drive system, and performance issues.
Detailed specifications for different models including dimensions and capacities.
Instructions for short-term and long-term storage to protect the unit.
Details on warranty coverage, customer responsibilities, and exclusions.
General| Cutting Width | 72 in |
|---|---|
| Engine Manufacturer | Kawasaki |
| Cutting Decks | 1 |
| Speed Range | 0-10 mph |
| Turning Radius | Zero-Turn |
| Wheel Size Front | 13 x 6.5-6 |
| Engine Type | Electronic Fuel Injection (EFI) |
| Deck Material | 7-Gauge Steel |
| Standard Features | hour meter |
