What to do if the Gravely Lawn Mower engine continues to run when the key is off?
If the engine continues to run when the ignition key is in the off position on your Gravely Lawn Mower, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean metal surface.
How to troubleshoot a Gravely Pro-Turn 460 EFI Lawn Mower when the engine doesn't start?
If your Gravely Lawn Mower engine doesn't start, there are several potential causes and solutions: * Ensure the PTO switch is in the off position. * Engage the parking brake. * Check and fill the fuel tank if empty. * Replace contaminated fuel with clean fuel. * Charge the battery if it's not charged, or clean and tighten loose or corroded battery cables. Also, inspect the spark plug wires and spark plugs, and check the Safety Interlock System. If these steps don't resolve the issue, there may be an electrical or engine fault, and you should contact your Gravely dealer.
What to do if my Gravely Pro-Turn 460 EFI doesn't drive?
If your Gravely Lawn Mower isn't driving, there are a few things to check. First, make sure the parking brake is released. Next, verify that the transaxles are not bypassed by ensuring the bypass valves are in the operating position. Also, check the hydraulic oil level and add oil if it's low.
What to do if my Gravely Lawn Mower does not drive?
If the Gravely Lawn Mower unit isn't driving, first ensure the parking brake is disengaged. Then, check if the transmission bypass levers are open and close them. Also, verify the hydraulic oil level and add oil if it's low.
What to do if my Gravely Pro-Turn 460 EFI cranks but does not start?
If your Gravely Lawn Mower engine cranks but doesn't start, the fuel tank might be empty, so fill it up. Another possible reason is a faulty spark plug, which should be replaced. Also, the air cleaner or fuel filter may be dirty; clean or replace them.
What does it mean when the malfunction indicator light is illuminated on my Gravely Lawn Mower?
If the malfunction indicator light is illuminated on your Gravely Lawn Mower (Models 992278, 992279, 992282, 992283, 992284, 992288, 992289, 992290), it means the system has detected an engine malfunction. Stop the engine immediately.
Why does my Gravely Lawn Mower creep when the steering levers are in neutral?
If your Gravely Lawn Mower creeps forward even when the steering levers are in the neutral position, it could be due to transaxles needing adjustment or the parking brake interlock requiring adjustment.
What should I do if the oil pressure light is on in my Gravely Pro-Turn 460 EFI?
If the oil pressure light is illuminated on your Gravely Lawn Mower, it indicates low oil pressure. Stop the engine immediately.
Why does my Gravely Pro-Turn 460 EFI engine not crank?
If your Gravely Lawn Mower engine won't crank, it might be due to several reasons. First, make sure the PTO is disengaged. Next, engage the parking brake. Check for loose or corroded battery cables, and if found, clean and tighten them. Also, verify if the battery is discharged and charge it if necessary.
What causes a Gravely Pro-Turn 460 EFI Lawn Mower engine to run when the ignition key is off?
If your Gravely Lawn Mower engine continues to run even when the ignition key is in the off position, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean, metal surface.
Warning and precautions for amputation hazards.
Warning and precautions for discharge hazards.
Warning and precautions for tipping hazards.
Safety during unit servicing.
Safety concerning bystanders.
Hazards related to loss of traction.
Warnings about rotating parts.
Precautions for hot engine parts.
Key safety rules for operation.
Importance of understanding operation and safety.
Safety measures to protect children.
Pre-operation checks and safety.
Safety guidelines for operating on slopes.
Precautions for handling gasoline and fuel.
Safety precautions during maintenance and service.
Instructions for assembling the seat.
Procedure for adjusting steering levers.
Diagram showing location of various controls and features.
Numbered list of all controls and features.
Step-by-step guide to starting the engine.
Initial operation and steering control.
Recommended service intervals for the unit.
Adjusting transaxles for excessive creep.
Adjusting parking brake interlock.
Ensuring the unit drives in a straight line.
Procedures for replacing mower belts.
Procedures for replacing the transaxle drive belt.
Steps to remove the mower deck.
Steps to install the mower deck.
Checking blade level and pitch.
Adjusting deck to be level.
Adjusting the pitch of the mower blades.
Issues related to the engine not starting.
Problems with the engine running rough or overheating.
Issues with the unit not driving or driving straight.
Problems with PTO operation or cut quality.
General| Cutting Width | 60 inches |
|---|---|
| Transmission | Hydro-Gear ZT-5400 |
| Spindle Material | Cast Iron |
| Ground Speed (Forward) | 13 mph |
| Ground Speed (Reverse) | 6 mph |
| Deck Type | Fabricated |
| Turning Radius | Zero-turn |
| Cutting Height | 1.0 - 5.5 in |
| Engine | Kawasaki FX850V EFI |
| Warranty | 5 years or 1500 hours (whichever occurs first) |
To Next Page
