To Next PageTo Next PageWhy does my Gravely Lawn Mower engine lack power?
If your Gravely Lawn Mower engine lacks power, start by checking the air intake system and fuel filter for clogs; clean or replace them as needed. Drain the tank and refill with the correct fuel type. Clean the cooling fins to prevent overheating and replace the spark plug.
What to do if my Gravely Pro-walk hydro 36HR PG Lawn Mower engine runs rough or stalls?
If your Gravely Lawn Mower engine runs rough or stalls, you should check a few things. Start by replacing the fuel filter if it's plugged and cleaning or replacing the air intake system if it's plugged as well. Clean the fuel cap vent and replace any stale fuel with fresh fuel. Also, replace the spark plug if it's not gapped correctly and adjust the choke if it's adjusted incorrectly.
Why is my Gravely Lawn Mower engine overheating?
If your Gravely Lawn Mower engine overheats, start by cleaning the cooling fins and ensuring the oil level is correct. Operate the mower at full-throttle and clean the cooling air intake screen. Replace the air intake filter if it's plugged and reduce ground speed if it's too fast for the conditions.
Why is my Gravely Pro-walk hydro 36HR PG Lawn Mower cutting unevenly?
If your Gravely Lawn Mower cuts unevenly, make sure the mower deck is properly leveled. Reduce your ground speed, especially when turning, and run the engine at full throttle. Sharpen or replace the blades if they are dull, bent, or unbalanced. Try changing your mowing pattern and adjust the tire pressure.
Why is my Gravely Lawn Mower deck vibrating?
If your Gravely Lawn Mower deck vibrates, ensure you are mowing with the engine at full throttle and tighten all loose hardware. Check and replace the mower deck drive belt and spindle drive belt if damaged. Tighten the blade bolts and sharpen or replace any dull, bent, or unbalanced blades. Remove the belt shields and clean any debris and check and adjust the sheaves.
What causes excessive vibration in my Gravely Lawn Mower?
If your Gravely lawn mower experiences excessive vibration, increase the engine speed. Inspect and replace worn or damaged deck drive belts and pump drive belts. Clean any dirt or debris from the drive sheaves. Tighten or replace any loose or damaged electric PTO or drive sheave. Replace or straighten bent or damaged cutting blades.
Why won't my Gravely Pro-walk hydro 36HR PG Lawn Mower move even when the engine is running?
If your Gravely Lawn Mower will not move with the engine running, release the parking brake. Add hydraulic oil if the level is low and allow the engine and hydraulic oil to warm if the oil is cold. Replace or adjust a slipping pump drive belt and close the pump bypass valves. Replace the pump drive belt if it is damaged or worn.
How to prevent my Gravely Pro-walk hydro 36HR PG Lawn Mower discharge chute from plugging?
If the discharge chute on your Gravely Lawn Mower is plugged, mow only when the grass is dry. Raise the cutting height and mow with the engine at full throttle. Reduce your ground speed and check the mower deck drive belt, replacing it if damaged or incorrectly installed.
What causes my Gravely Pro-walk hydro 36HR PG Lawn Mower engine to knock?
If your Gravely Lawn Mower engine knocks, check the engine oil level and add oil to reach the proper level. Reduce the load and fill the tank with fresh fuel of the correct octane. Increase the idle speed.
Why aren't the mower blades engaging on my Gravely Pro-walk hydro 36HR PG Lawn Mower?
If the mower blades on your Gravely Lawn Mower do not engage, replace the mower deck drive belt or spindle drive belt if they are slipping or broken. Inspect and install or replace the tension spring, if it's not installed or broken. Replace the PTO switch if it has failed and replace the 20-amp fuse if it is blown. Tighten any loose electrical connections and replace the PTO clutch if it is faulty. Inspect and repair faulty relay connections.
General| Engine | Kawasaki FS481V |
|---|---|
| Engine Power | 14.5 HP |
| Cutting Width | 36 inches |
| Transmission | Hydro-Gear ZT-2800 |
| Weight | 600 lbs |
| Fuel Type | Gasoline |
| Blade Type | High-lift |
| Deck Lift System | Manual |
| Wheel Size | 11 inches (front), 18 inches (rear) |
| Warranty | 2 years commercial |
