What to do if my Gravely Promaster 320 Lawn Mower won’t engage?
If your Gravely Lawn Mower won’t engage, here are a couple of potential reasons: First, the attachment might be blocked. To solve this, stop the unit, remove the key, and clear the attachment. Second, the PTO switch might be bad, in which case you'll need to replace the switch.
What to do if my Gravely Promaster 320 Lawn Mower makes no sound when I turn the key?
If you turn the key and hear no sound when trying to start your Gravely Lawn Mower, it could be due to several reasons. First, make sure the PTO is disengaged and the directional control pedal is in neutral. Check for loose battery cables and tighten them if necessary. If the battery is discharged, recharge it. A blown fuse could also be the culprit, so replace it if needed. Finally, the neutral switch might be improperly adjusted; in this case, adjust it according to the service and adjustment guidelines.
Why does my Gravely Promaster 320 starter click but not start?
If your Gravely Lawn Mower's starter clicks but the engine doesn't start, the battery may be discharged; in this case, charge the battery. Another potential cause is corroded battery cables, so clean the battery connections. If these steps don't resolve the issue, the starter may be damaged and require professional attention.
What to do if my Gravely Promaster 320 Lawn Mower cranks but won't start?
If your Gravely Lawn Mower engine cranks but doesn't start, first check if the fuel tank is empty and fill it if necessary. If the fuel tank is not the issue, the spark plug may be bad, in which case you should consult the engine manual. Finally, there may be an engine problem, so you should consult the engine manual.
What to do if my Gravely Promaster 320 mower won’t engage?
If your Gravely Lawn Mower won’t engage, it could be due to a blocked attachment. Stop the unit, remove the key, and clear the attachment. Alternatively, a bad PTO switch could be the cause, and should be replaced by a qualified technician.
Why is my Gravely Lawn Mower making abnormal vibrations or sounds?
Abnormal vibrations or sounds in your Gravely Lawn Mower can stem from several causes. It could be due to loose hardware, which requires checking and tightening all hardware. Another cause might be debris in the mower deck, which means you should clear any debris before starting the unit. Damaged mower blades or a damaged mower belt or one that is off the pulleys, which means you should replace the mower blades or install/replace the belt.
Why does my Gravely Lawn Mower engine keep running after I turn it off?
If your Gravely Lawn Mower's engine continues to run even when the ignition key is in the off position, it could be due to a disconnected ignition ground wire. Ensure the ground wire is connected to a clean, metal surface. Alternatively, the ignition switch might have failed, in which case it should be replaced by a qualified technician.
General| Brand | Gravely |
|---|---|
| Model | Promaster 320 |
| Category | Lawn Mower |
| Language | English |
Guides on manual content, service inquiries, parts, and product registration.
Customer responsibilities for delivery, assembly, and warnings against unauthorized replacement parts.
Explains safety signals, notations, general rules, and operator responsibilities.
Covers safety decal locations, rules, and the importance of operator training.
Step-by-step guide for mounting the mower deck and attaching the carrier frame.
Procedures to test safety interlock systems and control functions prior to use.
Identifies and explains key controls like throttle, deck lift, and PTO switch.
Covers pre-start checks, cylinder stops, emergency stops, and engaging the mower.
Outlines periodic checks for fasteners, lubrication, safety interlocks, blades, and belts.
Procedure to test the safety interlock system before each use for proper function.
Detailed instructions for removing and installing mower belts.
Information on inspecting, replacing, and sharpening mower blades.
How to adjust anti-scalp rollers for different cutting heights to prevent lawn scalping.
Procedure for leveling the mower deck side-to-side and adjusting pitch.
Detailed steps for adjusting blade height using deck lift brackets and height adjusters.
Guidelines for proper short-term and long-term storage of the unit.
Identifies common problems like mower not engaging or abnormal vibrations and provides solutions.
Lists and illustrates decals, deck covers, wheels, and mounting hardware.
Lists critical parts including belts, spindles, idlers, and mower blades.
Details product warranty coverage, exclusions, limitations, and customer responsibilities.
Instructions on how to obtain warranty service and contact information for support.
To Next Page
