EN - 29
CARBON CANISTER FILTER
Models 915208, 915232, 915234
(Figure 20)
Clean or replace the carbon canister filter
whenever the engine air filter is cleaned or
replaced.
ADJUSTING STEERING LEVERS
(Figure 21)
IMPORTANT: Adjust each steering lever
equally.
NOTICE: When adjusting steering levers for
the first time it is recommended that you
make adjustments in the following order.
1. Adjust Steering Lever Height
1. Remove mounting hardware that
attaches the handlebars to the upper
control arm. Move handlebar up or down
until the handlebar mounting holes are
aligned with the preferred adjustment
holes.
2. Install mounting hardware and tighten.
2. Adjust Steering Lever Width
1. Loosen hardware at the base of the
lower control arm (item 5).
2. Rotate eccentric spacer to move the
levers away from or closer to the
operators position (figure 22).
3. Tighten hardware.
Figure 20
1. Carbon Canister
2. Carbon Canister Filter
1
2
Figure 21
1. Handlebar
2. Upper Control Arm
3. Adjustment Holes
4. Eccentric Spacer
5. Mounting Hardware
6. Lower Control Arm
2
1
5
Adjustment 2
Adjustment 1
Adjustment 3
4
6
3
To Next Page
