the holder as shown. The tab will hold the cover in position,
until removal or installation of the battery is required.
❏ 1. Using the indentations in the aft end of the fuselage as
a guide, cut the slots for the elevator and rudder pushrods.
❏ 2. Temporarily fit the plywood landing gear former (1)
into the fuselage. Be certain it is centered and in the groove
in the fuselage. Use a fine-point felt-tip pen to mark the
inside of the fuselage on both sides of the opening in the
bottom of the landing gear former for the landing gear wires.
Assemble the Fuselage
15
To Next Page