Thank you very much for your recent purchase: GReddy Multi D/A
Gauge. We hope this instruction manual will be helpful to you whether
you are a novice or technician . Please keep this instruction manual in
your car to read anytime.
We made a tireless effort to develop the product for your safety and
comfortable car life. We think that our product could provide better
performance and convenience for your vehicle. However, there may
be a chance to lose the factory-offered safety by using our product.
Therefore, please read carefully in order for you to use safely and
comfortably at your own risk.
To the best of our knowledge, the information contained herein is
accurate. However, neither TRUST CO., LTD or any of its subsidiaries
assumes any liability whatsoever for the accuracy or completeness of
the information contained herein. All materials may present unknown
hazards and should be used with caution. In particular, improper use of
our products and their inappropriate combination with other products
and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the
sole responsibility of the user. Although certain hazards are described
herein, we cannot guarantee that these are the only hazards that may
exist. All service performed on internal parts and equipment should be
provided by qualified technicians.
Please remember the following signs as you proceed to read manual.
Warning : If you don’t follow, drive at your own risk.
Caution:
If you don’t follow, may lead to breakdown of your automobile.
Follow the directions to use properly.
Be advised to use properly
.
Attention
Important
Warning
Refer to your automaker’s manual to ensure the safety. If used wrongly, it may cause an accident.
Before parking, confirm no flammable objects under the car. Use caution with muffler which has hot
temperature after driving and may create a fire hazard when parked near dried and flammable objects.
Stop the engine if its not necessary. The exhaust ventilation contains poisonous gas and if you operate in
a closed space for a long time, it may cause you carbon monoxide poisoning.
Do not run the engine when you take a rest in the car. If taking a break while running the engine, there is a
danger of carbon monoxide poisoning.
Do not work shortly after the engine shutdown. There is a danger of burn injury because the entire exhaust
system is extremely hot.
Professional Installation is recommended.There is a risk of injury if done by an unprofessional person.
Make sure all mounting instructions & places are examined, and don’t let drop.
worngly installed objects would cause the fall and it is very dangerous.
Do not operate Multi D/A gauge while driving. It could cause a traffic accident.
Check the installed areas before you drive: around oil, water, fuel lines, and deterioration of them.
The mishandling of oil, water, and fuel lines would cause an engine breakage.
When installing sensors, use seal tape to make an installation surely.
Oil and water leaking would cause a catching fire and engine wreckage.
Operate outside or ventilated room when handling fuel lines which may induce fire.
Gasoline is flammable. It is dangerous to work around the fire items.
Before moving a car, make sure there’s nothing around the car. If don’t, may lead to the dangerous situation:
injury and property damage.
When using soldering iron and nipper, use properly. Failure to use tools may cause serious injury or illness.
Make sure there’s nothing under the driving pedals. It is very dangerous to leave something under the pedals
which lead to the non-functional brake.
To Next Page
General
