26
Operation procedures/pictures
● Press the connector of the drainage hose with
strength and turn the drainage hose
counterclockwise to take it off.
● Remove the big and small guide louver. Use your
fingers to bend them in the arrow direction with
strength to take off the guide louver. (As shown in
Fig.8-7)
● Screw out the screws that fix the guide motor to take
it off. (As shown in Fig.8-6)
● Unclench the clasp in the middle of the water tray
that fix the liquid crystal box to take out the liquid
crystal box.
8.1.4 Disassembling the evaporator assy
● At the back of the rear case, screw off the tapping
screws that fix the rear clamp and unclench the
clasp that fixes it into the rear case to take off the
rear clamp.(As shown in Fig.8-8)
● Screw off the tapping screws that fix the evaporator
on the rear case and the motor clamp. Unclench the
clasps and pull the liquid inlet pipe of the gas
collector on the back groove of the rear case slightly
outward. Pull out the left side of the evaporator and
pull the right side of the evaporator at the same time
to take it out along the grooves. Pay attention to
protecting the connecting pipe.(As shown in Fig.8-9
and 8-10)
Screws (2 pieces)
Guide motor
Fig.8-6
Liquid crystal box
Small guide louver
Guide motor
Big guide louver
Drainage hose
Fig.8-7
Rear clamp
Screws
Fig.8-8
Eva
To Next Page
Loading...
