17
Installation and Maintenance
Service Manual
8.1 Preparations for Installation
NOTICE!
Product graphics are only for reference. Please refer to actual products. Unspecied measure unit is mm(in.)
Please use the supplied standard ttings listed below as instructed.
8.2 Location for Installation
(1) The appliance shall not be installed in the laundry.
(2) The top holder must be strong enough to support unit’s weight.
(3) Drain pipe can drain water out easily.
(4) There is no obstacle at inlet or outlet. Please ensure good air circulation.
(5) In order to make sure the space for maintenance, please install the indoor unit according to the dimension described below.
(6) Keep the unit away from heating source, inammable gas or smoke.
(7) This is a concealed ceiling type unit.
(8) Indoor unit, outdoor unit, power cord and electric wire should stay at least 1m(39-3/8 in.) from the TV set and radio. Otherwise, these
electrical appliances may have image interference and noise. (Even if the distance is 1m(39-3/8 in.), when there is strong electric wave,
noise may still occur.)
No. Name Appearance Q'ty Usage
1 Wired Controller
1 To control the indoor unit
2 Drain Hose Assembly 1 To connect with the hard PVC drain pipe
3 Special Nut
1
To be used for connecting the refrigerant
pipe
4 M10X8 Nut with Washer 4
To be used together with the hanger bolt for
installing the unit.
5 M10 Nut (M10X8.4 Nut)
4
To be used together with the
installing the unit.
6
M10 Washer (Spring Washer
M10X2.6)
4
To be used together with the hanger bolt for
installing the unit.
7Insulation 1To insulate the gas pipe
8Insulation 1To insulate the liquid pipe
9Sponge 2To insulate the drain pipe
10 Fastener 8To fasten the sponge
To Next Page
Loading...
