Gree DUCT09HP230V1BD - Page 25

23
Installation and Maintenance
Service Manual
9.3.2 Drainage pipe installation
(1)
Insert the drain hose into the drain hole and tighten it with tapes, as shown in Fig 9.3.2.
(2)
Tighten the pipe clamp, with the distance between screw nut and hose smaller than
4mm(1/8in
.)
.
①
metal clamp(accessory)

drain hose(accessory)
(3)
Use sealing plate to make the pipe clamp and hose insulated, as shown in Fig.9.3.3.

metal clamp(accessory)

thermal sponge(accessory)
Unit: mm(in.)
 
Fig 9.3.2 Fig 9.3.3
(4)
When connecting several drain pipes, follow the instruction as indicated in Fig 9.3.4.
Ch
oose the drain collecting pipe that matches with unit capacity.
Unit: mm(in.)

Fig 9.3.4
Fig 9.3.6
Fig 9.3.6
Fig 9.3.7
Fig 9.3.7
Fig 9.3.8
Fig 9.3.8
Fig 9.3.5
9.3.5
F
i
g
9
.
3
.
5
 