31
Duct Type Split Air Conditioner
Service Manual
CONTROL
Fig. 3.16 Auxiliary Electric Heating Function Setting
Note:
E-HEATER can not be set in cooling, dry and fan mode, E-HEATER mark won’t be displayed. The setting is
shown in Fig.3.16.
3.4.12 Blow Function Setting
BLOW function: After the unit is turned off, water in evaporator of indoor unit will be automatically evaporated
to avoid mildew.
In cooling and dry mode, press Function button till the unit enters BLOW function, with BLOW blinking, and
then press Enter/Cancel button to turn on this function.
In BLOW mode, press Function button till the unit enters BLOW function and then press Enter/Cancel
button to cancel this function.
BLOW function setting is shown in Fig3.17.
To Next Page
Loading...
