32
Duct Type Split Air Conditioner
Service Manual
CONTROL
Fig. 3.17 Blow function setting
Note:
a. After setting BLOW function, turn off the unit by pressing On/Off button on remote controller, indoor fan
will run at low fan speed for 10 min. (BLOW shows).Meanwhile, if BLOW function is canceled indoor fan will be
turned off directly.
b. There is not BLOW function in fan or heating mode.
3.4.13 Quiet Function Setting
Quiet function consists of two kinds: QUIET and AUTO QUIET.
Press Function button till the unit enters quiet function setting state, Quiet or Auto Quiet mark blinks. In this
case, press ▲ or ▼ button to switch between Quiet and Auto Quiet and then press Enter/Cancel button to turn
on this function.
In quiet mode, press Function button till the unit enters quiet function. In this case, Quiet or Auto Quiet icon
blinks and then press Enter/Cancel button to cancel this function.
Quiet function setting is shown in Fig3.18.
To Next Page
Loading...
