1
CAUTIONS
ENSURE THAT ALL POWER IS DISCONNECTED PRIOR TO
ATTEMPTING INSTALLATION OF THIS HEATER KIT. THERE MAY
BE MORE THAN ONE DISCONNECT SERVICING THE UNIT.
REMOVE LINE VOLTAGE FROM L1 and L2 TERMINALS IN THE
CONTROL BOX. FAILURE TO DO SO CAN RESULT IN FIRE.
A MEANS OF STRAIN RELIEF AND CONDUCTOR PROTECTION
MUST BE PROVIDED AT THE SUPPLY WIRE ENTRANCE INTO CABINET.
USE COPPER CONDUCTORS ONLY
INSTALLATION MUST FOLLOW NATIONAL ELECTRIC CODE AND
OTHER APPLICABLE CODES
IF THIS APPLIANCE IS INSTALLED IN AN ENCLOSED AREA SUCH AS A
GARAGE OR UTILITY ROOM WITH ANY CARBON MONOXIDE
PRODUCING APPLIANCE, ENSURE THE AREA IS PROPERLY
VENTILATED
To Next Page
Loading...
