Gree FP-51BA2/A-K - CHANGING BATTERIES AND NOTICES

Wall Mounted Type
Fan Coil Unit Service Manual
16
CONTROL
4 OPERATION OF WIRELESS REMOTE CONTROL
4�1 Guide for operation – General operation
①
Press
SLEEP
button to set the sleep state.
②
Press
TIME ON
and
TIME OFF
button to scheduled the unit
ON/OFF
③
Press
LIGHT
button to control on and off the indicator board.(This function maybe not
available for some units).
4�2
Guide for operation-Optional operation
①
After powered on, press
ON/OFF
button, the unit will start to run. (
Note
: When it is
powered off , the guide louver of main unit will close automatically.)
②
Press
MODE
button, select desired running mode, or press
COOL
or
HEAT
mode to
enter the corresponding operation directly.
③
Press + or-button to set the desired temperature.
④
Press
FAN
button to set fan speed from
AUTO, FAN ,LOW MID
and
HIGH
.
⑤
Press button to select
SWING
mode.
4�3 Operation of wireless remote control
①
Press +and - buttons simultaneously to lock or unlock the wireless remote control. If it is locked, the
mark will display; when pressing any button, the mark will blink for three times but the air conditioner has no
despondence. If unlocked, the mark will disappear.
②
Switch between Fahrenheit and Centigrade.When unit is under Off state, press
MODE
and – button
simultaneously to switch between °C and °F.
5 CHANGING BATTERIES AND NOTICES
①
Slightly to press the place with , along the arrowhead direction to push the
back cover of wireless remote control. (As show in gure)
②
Take out the old batteries. (As show in gure)
③
Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show
in gure).
④
Attach the back cover of wireless remote control. (As show in gure)
NOTE
:
●
When changing the batteries, do not use the old or different batteries, otherwise, it
can cause the malfunction of the wireless remote control.
●
If the wireless remote control will not be used for a long time, please take them out,
and don't let the leakage liquid damage the wireless remote control.
●
The operation should be in its receiving range.
●
It should be placed at where is 1m away from the TV set or stereo sound sets.
●
If the wireless remote control can not operate normally, please take them out, after
30s later and reinsert, if they cannot normally run, please change them.
●
leakage liquid damage the wireless remote control.
Sketch map for
changing batteries