Multi Variable Air Conditioners Fresh Air Series Indoor Unit
6
Note:
The ex-factory set temperature is 18
℃
in cooling mode and 22
℃
in heating mode. If
the user needs to change the temperature setting, please contact after-sales service personnel.
3 Preparations for Installation
Note:
Product graphics are only for reference. Please refer to actual products. Unspecified
measure unit is mm.
3.1 Standard Fittings
Please use the supplied standard fittings listed below as instructed.
No. Name Graphics Quantity Function
1 Wired Controller
1PC To control the indoor unit
2 Union Nut Sub-assy
1 Set
To be used for connecting the
refrigerant pipe
3 Corrugated pipe
1
GMV-NDX125~140P/A-T
4
M10 Nut (Nut with Washer
M10×8)
4 PC
To be used together with the hanger
bolt for installing the unit.
5 M10 Nut (M10×8.4)
4/8 PC
To be used together with the hanger
bolt for installing the unit.
GMV-NDX125~140P/A-T: 4
6
M10 Washer
(Spring Washer M10×2.6)
4 PC
To be used together with the hanger
bolt for installing the unit.
7*
M10 Washer
(M10×Φ30×2.5)
4 PC
To be used together with the hanger
bolt for installing the unit.
8 Insulation
1 PC To insulate the gas pipe
9 Insulation
1 PC To insulate the liquid pipe
10 Fastener
8 PC To fasten the sponge
11* Hanger
4 PC To fix the indoor unit
12* M8 Nut (M8×6.8)
8 PC
To fix the hook on the cabinet of the
unit.
13*
M8 Washer
(Spring Washer M8×2.1)
8 PC
To fix the hook on the cabinet of the
unit.
14*
M8 Washer
(M8×Φ16×1.5)
8 PC
To fix the hook on the cabinet of the
unit.
15 Sponge of Drain Pipe
2 PC Wrap the joint of drain pipe
Note:
① No.7*, 11*~14* is only suitable to GMV-NDX224~280P/A-T.
② The packed attachments should be subject to actual objects. If there are any alterations, there
will be no further notice.
To Next Page
Loading...
