11
5. CARE AND MAINTENANCE
5.1. CLEANING THE APPLIANCE
WARNING
▪ Before cleaning, turn off the dehumidier and disconnect the power cord. Failing to do so may lead
to electric shock.
▪ Do not wash the dehumidier with water, it may lead to electric shock.
▪ Do not use volatile substances such as thinner or gasoline to clean dehumidier. Doing so may
damage the surface of the casing.
► Cleaning the Casing and Air Vents
▪ To dust off the casing, use a soft towel. If the case is grimy or
greasy, use a mild detergent to clean it.
▪ Use a dust catcher or brush to clean the air vents.
► Cleaning the Drain Bucket
Every few weeks, clean the drain bucket to prevent growth of mold,
mildew and bacteria. Use a soft brush to clean the inside of the
bucket, then rinse it.
Follow these steps to remove the lid of the drain bucket :
1. Position the shaft of the handle so that its particular shape is
aligned with the same shaped hole on the handle mount (as
shown in Fig. 7). Simultaneously pull on the mounts to free the
handle and remove it.
2. Unfasten all 4 clasps holding the lid in place (as shown in Fig. 8)
then remove the lid.
3. Once the cleaning is done, put the lid and handle back on. Make sure the oat of the drain bucket
is still positioned correctly. The side with plastic foam should be under the lid. Do not pull the plastic
foam off the oat.
FIG. 7 – Removing the bucket handle
Handle mount Hole Lid
Handle
Handle shaft
FIG. 8 – Unfastening the clasps
Clasps
Lid
FIG. 6 – Dusting the surface
To Next Page
Loading...
Need help?
General
