6
3
-/+
The humidity level can be set within a range of 80% RH (Relative Humidity)
to. 35% RH (Relative Humidity) in 5% reduce or at continuous operation.To
set the unit for continuous operation, press the - pad until the screen reads
NS.
6
TIMER
While the dehumidifier is in operation, press this pad to set it to automatically
turn off in 2 hours or 4 hours. While the dehumidifier is off, press this pad to
set it to automatically turn on in 2 hours or 4 hours.
4
NOTE: If Nonstop is selected, the dehumidifier will operate continuously at its
maximum dehumidification settings if attached to a hose to drain or until the
bucket is full.For drier air, press the - pad and set to a lower percent value (%).
For damper air, press the + pad and set to a higher percent value (%).
When you first use the dehumidifier, set the humidity control to 45% or 50%.
Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you
still have damper air than desired, set the humidity level to a lower setting or
select Continuous for maximum dehumidification.
Display
Shows the set % humidity level while setting, then shows the actual (± 5%
accuracy) room % humidity level.
5
FAN SPEED
Controls the fan speed.
Press to select either High, Medium or Low fan speed.
Set the fan control to High for maximum moisture removal. When the humidity
has been reduced and quiet operation is preferred, set the fan control to Medium
or Low.