9
What to do
Cause
Condition
Maintenance
Removing breakdowns
If a condition listed below occurs,please check the following items to
help you to save your time and cost.
Is the temperature of the room
The tube temperature sensor is failure
Plug the power supply cord into
Has the power supply cord been
twinkles.
unit can not be started in case operation
Discard the water in the drainage
The "Running" lamp
disconnected?
the outlet.
tank ,and then reposition the tank.
above36 Cor below3 C.
The protection device is actuated and the
case,please do not use the dehumidifier).
is under the bad environment(in that
or disconnected.
operate��
The unit does not
Is the " Red " lamp blinking?(The tank
is full or in a wrong position.
reassembled by competent service
The sensor must be repaired or
department".
To Next Page
Loading...
