Gree GMV6 DC Inverter VRF Units Service Manual
273
5.15 Removing and Installing Fan
Preparations
(1) Use the power circuit breaker to switch off the power of the GMV6 VRF system.
(2) Remove the unit’s panel, top cover and upper electrical appliance cover by referring to 5.1.1
Removing the Unit Panel.
Removing procedure
(1) Disconnect the fan connection port.
(2) Remove the blades by referring to the 5.14 Removing and Installing Blades.
(3) Remove the bolts as shown in the figure and remove the fan.
Installation procedure
(1) Install a new fan on the motor bracket and fix the fan feet.
(2) Install the blades by referring to the 5.14 Removing and Installing Blades.
(3) Connect the fan according to the original wiring.
(4) Install the unit’s top cover assembly and panel by referring to 5.1.1 Removing and Installing the
Unit Panel.
3 - bolt;
⑧
- blade.
5.16 Removing and Installing Electric Heating Belt
Preparations
(1) Use the power circuit breaker to switch off the power of the GMV6 VRF system.
(2) Remove the unit’s front panel by referring to 5.1.1 Removing and Installing the Unit Panel.
(3) Remove the compressor soundproof cotton and the soundproof cap (if there is a soundproof
cover, please remove the front cover of the soundproof cover); please refer to the instructions
and procedures.
Removing procedure
(1) Loosen the spring hook of the electric heater on the compressor.
To Next Page
Loading...
Need help?
General