Why my Gree Air Conditioner unit doesn’t work?
Your Gree Air Conditioner might not be working due to several reasons: a cut-off fuse or circuit breaker (replace the fuse or reset the circuit breaker); a power failure (restart the unit when power is restored); disconnected power supply (connect the power); insufficient remote controller power (replace the battery); or the remote controller being out of range (ensure it's within 8m).
What to do if my Gree Air Conditioner has abnormal cooling or heating?
If your Gree Air Conditioner isn't cooling or heating properly, check for these possible causes: blocked air inlets or outlets (clear any obstructions); improper temperature, fan speed, or wind direction settings (adjust via the remote or wired controller); open doors or windows (close them); direct sunshine (use curtains or louvers); too many people or heat sources in the room (reduce these); or a blocked and dirty filter (clean the filter).
What to do if my Gree Air Conditioner runs but stops immediately?
If your Gree Air Conditioner starts but stops right away, it might be because the air inlet or outlet of the indoor or outdoor units is blocked. Clear any obstructions to resolve this.
General| Model | GMV-335WM/G-X |
|---|---|
| Category | Inverter |
| Cooling Capacity | 33.5 kW |
| Heating Capacity | 37.5 kW |
| Power Supply | 380-415V/3Ph/50Hz |
| Refrigerant | R410A |
| Operating Temperature Range (Heating) | -15°C to 24°C |
| Net Weight (Outdoor Unit) | 320 kg |
| Operating Temperature Range (Cooling) | -5°C to 50°C |
Explains warning symbols and basic safety rules for operation and handling.
Covers safe practices for installation, operation, and handling of the unit.
Addresses safety concerns related to the installation environment and fire prevention.
Details the number of indoor units that can be connected to various outdoor units.
General safety precautions to be followed during installation, repair, and moving.
Lists the required pipe diameters for various outdoor unit models.
Outlines conditions and criteria for selecting the proper installation location.
Details the procedures for air tightness testing and vacuum drying the system.
Explains how to calculate and perform additional refrigerant charging.
Covers safety guidelines, circuit breaker, wire sizing, and electrical parameters.
A checklist of essential items to verify after installation before operation.
Provides reference values for judging the normal operation of system parameters.
A table listing common problems, their causes, and recommended solutions.
Comprehensive lists of error codes for indoor units, outdoor units, and system status.
To Next Page
