What to do if Gree GMV-335WM/H-X Inverter has abnormal cooling or heating?
If your Gree Inverter is showing abnormal cooling or heating, close any open doors or windows and draw any curtains or louvers to block direct sunlight. Reduce the number of heat sources in the room. Also, clean the filter if it is blocked with dirt.
Why is my Gree Inverter cooling or heating abnormally?
If your Gree Inverter is not cooling or heating properly, check that the air intake and outlet of both the indoor and outdoor units are free from obstructions. Also, make sure the temperature setting, fan speed, and wind direction are properly adjusted using the wireless remote controller or wired controller.
How to troubleshoot a Gree GMV-335WM/H-X Inverter that doesn't run?
If your Gree Inverter isn't running, first ensure it's properly connected to a power supply. Then, verify that the voltage is within the specified range. Check the fuse and breaker, replacing the fuse or reconnecting the breaker if necessary. Also, replace the batteries in the remote controller. Finally, make sure you are within the 8m control range of the remote.
What to do if Gree Inverter runs but stops immediately?
If your Gree Inverter runs but stops immediately, the air intake or outlet of either the indoor or outdoor unit might be blocked. Remove any obstructions to resolve this issue.
General| Model | GMV-335WM/H-X |
|---|---|
| Type | Inverter |
| Cooling Capacity | 33.5 kW |
| Heating Capacity | 37.5 kW |
| Refrigerant Type | R410A |
| Power Supply | 380-415V/3Ph |
Explains safety symbols and initial safety advice for users and installers.
Covers safe practices for installing, servicing, and handling the unit, including operational precautions.
Crucial safety guidelines, site selection, and installation precautions.
General principles for designing pipe layouts and required pipe diameters.
Procedures for installing refrigerant piping, manifolds, and their supports.
Procedures for air tightness testing and vacuum drying the refrigeration system.
Methods for calculating and performing refrigerant charging, including pre- and start-up steps.
General rules and safety precautions for electrical wiring and connections.
Lists essential items to check before installation and key component inspections.
General precautions and notes for performing debugging and operating the unit.
Lists common issues, solutions, and comprehensive error codes for indoor and outdoor units.
To Next Page