What to do if Gree GMV-504WM/H-X Inverter has abnormal cooling or heating?
If your Gree Inverter is showing abnormal cooling or heating, close any open doors or windows and draw any curtains or louvers to block direct sunlight. Reduce the number of heat sources in the room. Also, clean the filter if it is blocked with dirt.
Why is my Gree Inverter cooling or heating abnormally?
If your Gree Inverter is not cooling or heating properly, check that the air intake and outlet of both the indoor and outdoor units are free from obstructions. Also, make sure the temperature setting, fan speed, and wind direction are properly adjusted using the wireless remote controller or wired controller.
How to troubleshoot a Gree Inverter that doesn't run?
If your Gree Inverter isn't running, first ensure it's properly connected to a power supply. Then, verify that the voltage is within the specified range. Check the fuse and breaker, replacing the fuse or reconnecting the breaker if necessary. Also, replace the batteries in the remote controller. Finally, make sure you are within the 8m control range of the remote.
What to do if Gree Inverter runs but stops immediately?
If your Gree Inverter runs but stops immediately, the air intake or outlet of either the indoor or outdoor unit might be blocked. Remove any obstructions to resolve this issue.
Lists critical safety measures for installation, repair, and moving of the units.
Provides conditions for selecting the optimal installation position.
Specifies maximum pipe lengths and height differences.
Details the procedure for performing an air tightness test.
Provides requirements and procedures for vacuum drying the refrigeration system.
Explains how to calculate the total refrigerant charging amount.
Details the step-by-step process for pre-charging refrigerant.
Describes the procedure for charging refrigerant after initial pre-charging.
Provides crucial safety notices and requirements for electrical installation.
Lists power supply specifications, circuit breakers, and wire sizes.
Details series connection requirements for communication bus.
Details necessary preparations before conducting the test run.
Provides important notices and precautions to follow during debugging.
Lists common issues, causes, and solutions.
General| Category | Inverter |
|---|---|
| Cooling Capacity | 14.0 kW |
| Heating Capacity | 16.0 kW |
| Power Supply | 380-415V/3Ph/50Hz |
| Refrigerant | R410A |
| COP | 3.6 |
| Indoor Unit Noise Level | 42 dB(A) |
To Next Page