DC Inverter Side Discharge VRF Ⅱ for North America
48
During debugging, a click on “Break” can stop debugging. Click “Start” to resume
debugging and then debugging will be finished step by step. For No.10 ODU Valves
Check Before Startup, there are “Back” and “Skip” buttons. If there is error in this step, you
can back to step No.9 and click “OK” to restart debugging on step No.10. If the error in
step No.10 is U6 error (valve error alarm), you can click “Skip”. In other cases, “Skip”
button is null.
Step 11, 13 and 14 are reserved steps. And step 13, 14, 15 and 16 are steps in parallel
(only one of the four will be selected according to actual needs).
4.4.4 Control units
Click icon of “Setting” on menu bar and select parameter settings, which include “Gateway
Settings”, “IDU Settings”, “System Settings”, “Project Number Conflict (In case there is
project number conflict in indoor units, other functions will be shielded. Then this
parameter needs to be set in order to eliminate the conflict)” and “System Historical Info”.
Click the corresponding set and adjust the parameters.
To Next Page
Loading...
