To Next PageTo Next PageWhy is my Gree Vita GWH07ATA-D3DNA3A/I Heat Pump compressor not working?
The compressor in your Gree Heat Pump might not be operating because the unit was recently restarted or the operation mode was recently changed. A 3-minute protection delay is triggered to protect the compressor. Wait until this delay has elapsed.
What to do if my Gree Heat Pump indoor unit does not appear to be operating?
If your Gree Heat Pump indoor unit isn't working, it could be due to several reasons: * A power outage: Wait for the power to be restored, then restart the unit. * A loose power cord: Firmly push the plug into the power outlet. * A tripped circuit breaker or blown fuse: Replace the fuse or reset the circuit breaker, ensuring no other appliances overload the same circuit. * An active switch-on timer: Cancel the timer using the remote control or wait for the unit to start at the set time.
How to get rid of bad smells from my Gree Vita GWH07ATA-D3DNA3A/I?
If your Gree Heat Pump emits undesirable odors, it could be due to odors caught by the unit or a dirty dust filter. Remove any odor sources near the indoor or outdoor units and check and clean the dust filter.
Why does my Gree Vita GWH07ATA-D3DNA3A/I indoor unit make cracking sounds?
If your Gree Heat Pump indoor unit emits cracking sounds, especially after being turned on or off, it's a normal phenomenon. The plastic components are subject to thermal expansion and contraction due to temperature changes, so no action is required.
Why does my Gree Vita GWH07ATA-D3DNA3A/I indoor unit sound like flowing liquid?
If your Gree Heat Pump indoor unit emits a sound of flowing liquid, especially after being turned on or off, it's a normal phenomenon. The refrigerant inside the unit is moving due to operation starting, which produces this sound, so no action is required.
Explains hazard symbols and their meanings for safe operation.
Outlines essential safety rules for operation and maintenance to prevent hazards.
Details the components and parts of the indoor unit for user identification.
Details the components and parts of the outdoor unit for user identification.
Identifies and explains the function of each button on the remote control.
Provides fundamental steps for operating the heat pump and recommendations.
Describes various functions and how to set them using the remote control.
Provides instructions on how to clean the surface of the indoor unit.
Guides on how to remove, clean, and reinstall the dust filter for optimal performance.
Outlines tasks for preparing the unit before and after the operating season.
Lists error codes displayed by the unit and their corresponding solutions.
Helps diagnose and resolve common issues with the heat pump.
Details the warranty terms, coverage, and exclusions for the product.
General